Ei ole normaalia. Olet siis laittanut sivuäänen kuuluviin "menu - st l - hold edit". Käytännössä tuossa kohdassa säädetään sivuäänen tasoa.
Vastaava vika ollut KR7X. Sivuäänen source pitää olla oikea. Joskus mulla K2 on kadottanut sivuäänen omia aikojaan ja se on pitänyt käydä muuttamassa. Eli edit modessa täytyy painaa display jolloin source muuttuu, sivu 86.
Toivottavasti ei ole tämän kummempi vika
73 Jukka, OH4MFA
K2/100 #4293
Hi
Make sure you have the right sidetone source selected. You need U6-25 if your
control board is not modified for the KIO2 or KPA100. Select sidetone level and
tap the display button to change the source
Don Brown
KD5NDB
----- Original Message -----
From: Hank Lonberg
Sent: Sunday, October 13, 2002 10:17 PM
To:
elecraft@mailman.qth.net
Subject: [Elecraft] K2 Align + Test, Part 1
Have started building K2 #2757 and have progressed to this point. In
going thru the steps in Align and Test part 1, it passes the "smoke"
test and all others except Audio Amplifier and Tone Generator Test... I
have absolutely no side tone when I go the St L and attempt to activate
the sidetone. Zero zilch. I have gone over the control board and
verified component placement and solder joints. I have installed the
sidetone mods of WJ4P but all else is stock. I'm not sure the appendix E
trouble shooting apply this early in the construction of the unit. I
have the latest firmware and made sure that the side tone source is
u6-25. Which has 2.8 v dc on it at St L 50. Power supply is plenty
adequate with 30a capacity.
Need some thoughts on tracking this down on or off the list.
I was really having a ball till this....
73
Hank / KR7X
IH9P Contest Team
Tikirriki Constest Club